View Single Post
  #65  
Old 10th January 2018, 22:14
275NART's Avatar
275NART 275NART is offline
Senior Member
 
Join Date: Mar 2015
Location: South Carolina, USA
Posts: 102
275NART is on a distinguished road
Default




The shaft already had a splined to 3/4"dd joint where it attached to the steering rack on the saturn. It was also the perfect length and that made it easy to connect to the stainless steering shaft material I purchased. I am going to anchor the section of steering shaft that runs parallel to the inside of the frame rail using a 3/4" heim joint. I will weld a threaded bung in the frame and the heim will thread in to that. It will also allow the steering shaft to be pushed off the frame rail a little bit as well. You can see there is some interference with the joint and the frame rail close to where it comes through the firewall.
Reply With Quote