Quote:
Originally Posted by Nigbo
Peter
excuse for jumping in on this, but i got mine from from ABC (Anglia bearing Company) part no. MP061F39 (male only available).However when i contacted them i had the last one, i tried to get an additional back up but it seems like they were manufactured specially (was it for Mike ?) as a job lot . I phoned round about 5 other specialist companies and basically the answer seemed to be that no one did a 3/8 UNF male thread and a 10mm rose joint hole.
Mike may have better answers. I had to have a collar machined up anyway to join the male joint to the servo push rod thread. I found in my Marlin i had to shorten both the rose joint thread and pushrod thread length slightly to get them to fit and still have a decent amount of thread in the collar. So there is no reason the collar could have different threads at each end 3/8 facing the servo and 10mm to meet the male 10mm rose joint.
Nigel
|
There is an interesting back story here which may prove useful to know......
My rose joint solution was to source a 10mm female rose joint and weld a 3/8" x 20mm long collar collar to it.
See post 653 in this thread. Whilst I am 100% confident of its structure (it operates only in compression), I felt others may want an off the shelf solution, - hence the Anglia Bearing 3/8" male threaded 10mm rose joint and a 3/8" collar, which all simply screws together.
If this is no longer available off the shelf, I would be happy to get a 10mm rose joint professionally welded to a 3/8" collar, as per my own arrangement, for anyone wanting to go down this route. Send me a PM.
Mike