...firstly, you did well to get a spec from Marlin. Best I got was set everything parallel and go from there!
That said, I started out with Elise settings and tweaked a bit. Ended up with slight toe out on front 0.5 - 1mm and fairly big toe in on the back (approx 1.5 - 2mm each side). I found that this gave a nice neutral set up with a bit of oversteer on bends when lifting off (~easily controlled with the right foot!)
...I finally set all of this using the link posted above (elantra club) and can vouch that fishing line, conduit and a ruler worked absolutely fine....in fact better results than I got from a 'pro' set up.
(PS :- Only took about 2 hours all in to adjust too)
Rich
|