I've got my pulley adaptor back now so that can go on and complete the installation of the water pump, alternator etc etc.
Whilst the front end is off I've also lowered the floor section under the pedals to allow for my size 12's ! Dropped it by 50mm so the toe of even my biggest boots don't snag on the underside of the peddle box !
Whilst doing that little job I noticed that one of the master cylinders was leaking brake fluid so I've whipped that out and ordered a new one.
The photos below show the over size radiator and mountings attached to the chassis along with the front clip lower mountings. That's all good now and ready for final fit. See also the extra small Coke can size alternator, really useful when you are stuck for space.
Custom Chrome helped me out with all the tight mandrel bends in mild steel that I was after. Highly recommended.
Last edited by Lucky@LeMans; 5th January 2019 at 15:20..
|