[tony-g]

Hi all

I am about to start fitting my bodywork and I am looking for any tips and advice before I start so, I do not make a pigs ear of it.

As I understand you bolt the front and rear panels to the side panels and then attach the body to the chassis. Is this after or before you attach the side panels to the chassis? Do you fix the front and rear body panels first then shim them up to get the best fit. Are there any good tips to getting the body to fit right?

Are the inner and outer side panels joined together before trying to fit them and is there much trimming required to get a fit. There appears to be quite a bit to remove from the inner side panel to avoid the rear role bar uprights and rear bulkhead capping panel

Any help would be very welcome

Regards tony g