A little progress made to the sub frame and boot frame.
Started making a screen center support pillar out of ally that will also be the mount for the rear view mirror, once it's finished i will post some pictures.
IMG_4725.jpg
Started work on the boot frame which i had to do with the body in place to work out where the box section would fit. Due to the body being in place the welds are not the best as the room to work in was limited but will finish the welds once the body is removed.
One thing that the frame has pointed out due to the fact i made it square and equal dimensions is just how far the body is out from one side to the other.
IMG_4729.jpg
Fabricated a frame out of 20 x 20 box section to mount the pedals and brake/clutch cylinders. It looks like the original brake/clutch master cylinders are too high and will obstruct the bonnet so i will have to look around for a solution.
Has anybody found a solution to this problem, maybe a remote reservoir!
IMG_4730.jpg
Added 50 x 20 box section around the rear sub frame which i may use to mount the seat belts eye bolts.
Also fitted a plate to mount the hand brake pivot bolt.
Well that's it for now, see you all soon.