Bit more progress, and the body is on!!
Body on by
Steve Ward, on Flickr
Fitting to the tub was relatively easy with no cutting or rework necessary. When it's on the deck though, its sitting high at the back (even though I fitted a 1" lowering block to the spring!) and needs lowering by about another 40mm, probably by modifying the vertical links and dropping the spring mounting points.
Came to fit the bonnet though and things are not so good!
Both of the SU's clash:
IMG_1720 by
Steve Ward, on Flickr
And the rocker cover:
IMG_1721 by
Steve Ward, on Flickr
The SU's will be fairly easy with a bonnet blister to suit, and I'll take the opportunity to use it as an air intake for the carbs too.
The rocker cover not as simple. I'm thinking of cutting around the perimeter of the existing bulge, lifting and then glassing back in about an inch higher.
Did anyone else get this, and if so what approach did you take??
Cheers
Steve.