[275NART]

A little update here, A lot has been going on for me but I have some progress to report. Doors have been cut down and roughly mocked up. I will need to build back the jams and door frames.












A friend scanned a scale model I have and is working on scaling and figuring out how to slice into 2d sections so I can build the buck from it. I have a few ideas how to translate the sections to wire, either using a projector, plotting it on paper, or CNC in cardboard or plywood. This part doesn't have to be pretty as long as it's accurate. The nose and tail sections will likely be CNC'd in foam to capture all the detail.









I'm hoping the wire buck might turn out something like this