Hi,
I need some advice please. When I was replacing the heater hoses I've noticed the rubber in the picture below has split. Is it possible to fix/glue this or it need to be replaced?
I have looked in the Haynes manual and Internet trying to figure out the part name/function so I can order one, but no luck. It is located between the manifold and the carburetor.
IMAG1111.jpg
And it goes from here:
IMAG1114.jpg
My wild guess would be that it has something to do with a vacuum? so the rubber need to seal this point, but as I said it's just a guess...any advice would be helpful and appreciated.
Thank you.
D