Hi all,
Here is an update of my build progress over the last couple of weekends. It was the time to finally tackle the welding.
I fabricated the pedal plate and welded it to the frame. I am very happy with the result and my welding is getting better all the time (sorry for the photos orientation).
I did not have any other tool to cut 6mm steel plate so I have used a grinder to make the openings for the pedals - they are not the best looking but will do the job.
IMG_1653.jpg
I have bought this cheap pillar drill quite some time ago and it finally got used to drill the holes for the pedals and the master cylinders.
IMG_1655.jpg
IMG_1656.jpg
IMG_1654.jpg
I have decided to use my fibreglass bulkhead, so I will cut out the part where the pedal plate is.
IMG_1673.jpg