Still chipping away...
Got a very brief break in the rain to work in...
I put the "blank" for the cigarette lighter hole in.
At which point I decided it might actually look better with some wood filler in the hole.
I cleaned up the excess expanding foam & really should have masked off the area first.
I mixed up some filler and covered the back of the cigarette lighter hole "blank".
I then covered the top of the expanding foam.
Plus the area behind the end of the dash where I welded in a support bracket the other day.
I did the same behind the end of the dash on the other side too.
( Not a great photo. )
I made templates for the battery cut off switch & two lengths of small box section.
As I want to re-enforce the metal dash before I bolt the switch into place.
I then cut the box section roughly to length, as I will find tune it to fit.
At this point I couldn't see how it fitted in the dash as I'd already covered the bulkhead.
In fact, the sky was so dark, & it had got so cold, I had packed almost everything away.
Sure enough, shortly after that last photo was taken the rain returned.
Until next time, take care, Paul.
