[275NART]

Next I have started on the rear axle. As I may have mentioned earlier it is out of a late 90s ford explorer. Disk brake 3.73 gears, 31 spline axles. It was originally 59.5" but by cutting down the driver's side axle tube and using another passenger axle I could make it 56.5" to match the front axle width.



no turning back now...

Using a little angle iron on either side allowed me to keep everything true while I tacked it up. I used a straight edge on the axle tube all the way around the circumference to double check as well.




Now I can move on to fitting it up in the car with adjustable link bars and brackets.