View Single Post
Old 21st May 2012, 16:38
limpabit's Avatar
limpabit limpabit is offline
Senior Member
Join Date: Oct 2004
Location: Basildon, Essex
Posts: 1,800
limpabit is on a distinguished road

Found problem. Driveshaft too short! So was a problem waiting to surface. Knuckle was ok during engine fitments and fabrication. Can only think due to suspension changes etc. These things are here to test us.

Knuckle bearings took a little scrape. So ordered another driveshaft of the same for 18. But ordered a zt v6 one as well for 18 which is 1.5" longer so hope between the two, can make a correct length one. Else it's custom.
Reply With Quote