Thread: Dual 7" Servo
View Single Post
  #647  
Old 12th November 2012, 13:06
Patrick's Avatar
Patrick Patrick is online now
Senior Member
Enthusiast
 
Join Date: Feb 2005
Location: Hampshire
Posts: 2,462
Patrick is on a distinguished road
Default

Thanks Dennis

I think it would have been Ok without the rose joint as there is minimal movement. On thinking about it I decided to do it anyway as I had everything out and it meant removing any slop between the pedal and the servo - even if it was minimal. As a technical solution I like it better than the old setup. Also have all my pedals on needle bearings so it made sense to have the connection to the servo on a bearing too.
Reply With Quote