View Single Post
  #115  
Old 23rd December 2018, 23:47
deni deni is offline
Senior Member
 
Join Date: Jun 2015
Posts: 290
deni is on a distinguished road
Default

Next it was time to decide what needs doing before the body is on. I have bought a new welder and started practicing welding to improve the frame. I have been reluctant to start welding - I have an arc welder but I was not confident that I would be able to use it properly.

My new welder is a flux core, gases MIG welder, which seemed a bit easier to use.



IMG_1544_1024.jpg


My first attempt to put the wire in the welder...Inevitable rookie mistake...


IMG_1542_1024.jpg


My frame came without the pedals attachment plate and the base for the prop shaft tunnel, so I will have to weld these on. I will also need to strengthen the area around the steering column, brace the area behind the seats and weld a steel tube between the rear outriggers to stiffen the back of the chassis a bit. I will post photos when I start doing this after Christmas.

First practice welds were not good at all, as I had to learn which power and wire speed settings are most suitable, though I have made a bit better welds after a few attempts.

IMG_1547_1024.jpg

IMG_1549_1024.jpg
Reply With Quote