Flywheel and clutch back on the engine , starter motor bolted on ...exhaust manifold re-fitted ( I had to cut and shut the tubular manifold to make it fit ... ) , alternator bracket and alternator in place too ...and then I fitted the engine back in the car which was an absolute bastard to do on my own as its a snug fit and has to be located in a particular way to clear everything ... an engine hoist , trolley jack , 2 scissor jacks and a pry bar did the job ... but shes in ...
I took the opportunity to fit new brake lines whilst the engine was out and access to tucking them away neatly was better ...
The body is back on for storage purposes but will be off again as part of starting to clad the bulkhead and do the floor ...