Managed to get 4 hours in on the car today .
The bonnet pins I made yesterday had cured overnight , so a quick clean up and my nylon spacer added with a washer and the bonnet was ready to fit.
(Luckily whilst I was in Wicks yesterday I spotted that they had put the 250 SWB bonnet spacers they sell in the wrong aisle and they were in the 'door stops' category and priced at 49p a pair !!)
I drilled holes in the fixing plates to allow the tiger seal to bleed through and grab the bracket better ...
rest of the afternoon was spent mostly removing stuff ...rear bumper and all its bracketry in preperation for a Jeff H rear framework to be fitted.
seat belt mounts were cut off as this ones getting a harness bar ..I welded 4 ringbolt seat belt mounts into the car as well ...2 on inner cill where a handy grommet lives and two on the rear of the tunnel...
final job of the day was to remove the passenger side boot hinge ...
more tomorrow ...