Quote:
Originally Posted by Alanlionheart
Hi Peter
.....However, my question is in regard to what you use to "clean up" the chassis and other parts as I have never done this before?
Also, although I am OK about Hammerite I notice that they have a variety of options including a waxoyl product designed for protecting a chassis and general underbody. Is that what you have been using?
|
Hi Alan,
welcome to the world of kitcars!!
How to 'clean up' donor parts, well that's a long subject worthy of it's own thread but I'll briefly describe what I do....
If it's really oily and greasy the most effective and fast cleaner is just neat petrol. Not very environmentally friendly or safe but it is the most effective. (I think garages use a paraffin based parts cleaner.)
If the item is just dirty and not too oily I use Bilt Hamber 'Surfex HD' which works very well.
For de-rusting I use Hammerite 'Rust remover gel' (thanks Robin!) but if it's small enough to immerse the part I use Bilt Hamber 'Deox-C'. I just mix up a bucket full and pop them in overnight and they come out the next day with no rust. You must clean them with Surfex HD first or it doesn't work so well. I call it my magic potion!!
On my chassis it was just a case of lots of elbow grease. Basically a variety of wire brushes in an electric drill and lots of emery paper on a rubber sanding block.
For degreasing before painting and for cleaning small parts like bearings, engine parts, CV joints, etc, I use Brake Cleaner.
There are lots of exotic anti-corrosion paint coverings available but most are very expensive. For this build I'm just sticking to black Hammerite Satin. It will probably last longer than me!!
Finally, if you are a complete novice then I can recommend you start buying a couple of the kitcar mags as they have lots of articles and reviews of the various preparation methods, etc.
Good luck.....
....peter