Here's some pictures .....
You can see the wooden bracing thats been added ...a box on the rear to give the mould stability again when upside down and braces in the doorshuts too to stop it folding across the shuts ...
When the mould is off , Glan wants to add removable legs to the mould , so it will act as its own table when upside down ...
The flat areas either side of the bulkhead are the start of the bulkhead addition ...the bulkhead on the chassis I borrowed is destined for a S*mmio project , so I can't trim it and move it back ...that's going to be done using an alternative bulkhead when the plug has been removed and disposed of ...