Hi guys, I'm back from holiday and back in the garage.
I haven't done a great deal since getting back, apart from mounting the rad - but I did get the engine loom down from the shelf where it's languished for the past 18 months or so.
A lot of the sheathing on the loom (not the individual cores, but the outer wrapping) is in a pretty bad state - it's breaking up as it's become britle with age.
I'm planning on stripping it all off and re-covering it all - but I'm unsure as to what to use. Should I use non adhesive loom tape, cloth tape, good ole' sticky insulating tape or some sort of split loom? Has anyone else had to do this?
Whatever the general consenus is, Frosts will be getting some money chucked at them I guess....
