View Single Post
Old 20th February 2019, 02:25
Welshkiwi Welshkiwi is offline
Senior Member
Join Date: Aug 2017
Location: Auckland, New Zealand
Posts: 296
Welshkiwi is on a distinguished road

Originally Posted by Jaguartvr View Post
On my build, I turned the alloy bumper strengthener upside down. This gave me a flat boot floor that I was able to bolt the boot infill panel too (with a bit of modification). The boot infill panel was strengthened as well and made a great support for the rear body clam.
Thanks for the info Jag, ill bear that in mind when trying to work it all out. I think I remember attempting to spin it round when I stripped the car and found an attachment bolt seize after half a thread turn. It torqued back up ok but I may be tempting fate if I attempt to get it back off. Well see......if I can work out the right heights and use wide enough/thick enough ally angle slotted and bolted I may be able to get the right support and leave it where it is. Thanks fella.
Reply With Quote