Friday - Afternoon:
The clouds did not look very promising when I got back, so I didn't remove the covers fully when I started the engine.
Next I marked up where the bonnet hinges come close to the bonnet.
As the driver's side had very little clearance...
Compared to the passenger side.
I then ran my angle grinder across the filler I'd applied in the morning.
Before taking a deep breath and removing the bonnet.
Which left the front end of the car feeling very sorry for itself.
Unfortunately, at this point in time I was on my own, so it was a bit of a struggle to get the bonnet…
Into the house...
Through the kitchen and onto the patio...
And then down the length of the garden and into the Summer House.
( Which needed a major tidy up to clean enough room for it to fit. )
Then it was time to pack up and head out for an early evening meal with my family.
So until next time, take care, Paul.