Thread: Ozi 206 dino
View Single Post
  #22  
Old 30th May 2015, 12:21
ozi jim ozi jim is offline
Member
 
Join Date: Apr 2015
Location: Sydney Aust
Posts: 72
ozi jim is on a distinguished road
Default

Today I built the inner CV joints.
I have 2010 corolla drive shafts as they fit the wheel hubs.

My aim with all this stuff is to keep the match up as simple as possible.
I was not sure about how to marry up to the 01E audi box as the corolla has a splined shaft on its CV to go into their gearbox.

The other day I was working on a mid 2000 VW golf and I noticed the inner CV and flange was separate, somehow it was jointed I am presuming welded.

I went to the steel supplier and grabbed 4 bollard caps.

First thing was to make the base , I used a 50 cap to centre the SS cap that I have machined to a ring.
Once centered I clamped the SS ring and removed the 50.
I weld the SS ring on the inside, this becomes the locator on the 01E flanges.

P5300071.jpg
P5300072.jpg

I chopped the shaft of the end of the toyota CV, this leaves a 40mm dia spigot.
I then machined the center of the large disk to 40mm.

I machined a ring out of some steam pipe ,this fits between the main disk and the CV.
I tacked everything then put it in the lathe to check it then welded.

P5300065.jpg
P5300067.jpg

Last edited by ozi jim; 30th May 2015 at 12:31..
Reply With Quote