It is simply slots in the inner skin only although you need to slot the returns to allow it to bend.
It feels a very solid panel, I was surprised how much it came in with the ratchet strap.
Before you start measure how much the bottom edge of the bonnet stick out past the sill, I had about 15mm. I pulled it in 25mm at the back and 30mm at the front simply because this was where my first tensioning of the ratchet strap brought me to and I was just intending to use it as a first reference point expecting to have to tighten or losen the builders bands before glassing the slots up.
As I got it right on the first attempt it makes me a genius......or it could be down to luck, but I prefer genius!
It is most important to measure across the bonnet at the front and rear where it meets the sill to give you a reference point.
Last edited by Jaguartvr; 29th May 2016 at 15:40..
|