View Single Post
  #1  
Old 2nd May 2010, 23:10
Bottlethroddy's Avatar
Bottlethroddy Bottlethroddy is offline
Junior Member
 
Join Date: May 2010
Location: Bristol
Posts: 2
Bottlethroddy is on a distinguished road
Smile Hi from Newbie, and also engine brain picking :)

Hello all, great forum you have here

Firstly, ill introduce myself, my name is Lee, and I run the Performance Nova Group. Ive built quite a few road and track going Novas, most recently a 3.0 V6 2 door saloon

My next project will be slightly different, hense why I have registered on here as I will be leaving the comfort zone of the GM parts bin and I'm essentially planning to build a 'kit car' based on a nova monocoque.

My plan is to use Mazda MX5 running gear (front and rear subframes), i'm reasonably good at fabrication so this isn't the issue, my issue is my lack of knowledge of engines outside the vauxhall scene.

My wish list is reasonably short, I'm after a reasonably light engine (would consider a V6 but no V8's), and if possible, mappable to 280- 300bhp with no need for bottom end strengthening. My reasons for this are simple, Ive built a fare few high performance engines in my time, and i've also had my fair share of disasters, so much so that i now consider the engine to be a consumable (lol), in which case a stock engine which can be readily replaced if the crank case decides to launch forth onto the floor.

Im obviously looking at turbo lumps, but would possibly consider a SC IF the engine I use with it requires little modification to run one. Why so much power? I intend to have a dabble at drifting as well as my usual hobby of track days and qtr mile action (vauxhall shows tend to be based around drag strips rather than circuits)

Obviously the engine will also need mating easily to a rear drive g/box of some descripton so that is a big factor. I know vauxhall engines can be mated to ford gearboxes with relative ease due to the rally boys' fondness for running XE's in escorts, but again, thats where my knowledge runs out in that respect. Ive also looked into Nissan SR20 lumps, but have been told they take a bit of a wad throwing at them to make that sort of power.

Any suggestions would be fantastic as it opens up avenues of investigations for me.

Thanks for any responses, and I hope to stay around and post up progress of the thing when I start it
Reply With Quote
Available from eBay