Thanks Peeps, not sure about the froid bit, but sharkskin grey is what my boat is painted. It like a light green!
Finally made some progress today. Made up two bits of ply to go in the nose cone. They will duct air into the radiator, plus as they slot over the abs bumper they will support the front as well. Here they are just pugged in.[IMG]
[/IMG]
I also wanted to improve how the front wing runs into the front valance, losing the corners and also adding an upstand to add support and strength. I cut away the flange, tapered the glass and screwed on two pieces of plastic sheet. More plastic on edge plus some tape and we now have a former for some [IMG]
[/IMG]glass.
[IMG]
[/IMG]
If I have enough drive I may go back down to the workshop this eve and glass it in, once the kids are in bed!
I also taped in the small divits for the wipers. Just using corners of a small paint tray as in duty moulds. The grey stuff is gell coat.
[IMG]
[/IMG]