Dry fit and exhibition revs only.
I fitted the MWS Jaguar wire wheel adapters today and here it is:
The adapters fitted perfectly in terms of bolt PCD and diameter. There was <1mm play against the hub centre as well- result.
My only reservation is that the holes in the adapters are 45deg countersunk whereas the bolts have a 60deg bevel. The standard bolts clear the curly hubs. I did try my cone washers but that would need the bolt heads to be trimmed slightly. I'm not convinced that the washers are the best solution anyway- anyone know of 45deg chamfered wheel bolts? M12x40mmx1.5mm pitch?
