Not played with ECU as I've had to reinstall everything onto the laptop I was using to run the Hondata software - hoping to give it a go tomorrow!
I've also read somewhere about fitting a resistor to one of the ecu pins to mimic a heater, but this may be specific to American ECUs.
I'd welcome the chance to have another chat and look at your car, and to see how your ecu is set up. I'm about 3 miles outside of Dorch, and you'd be welcome to pop round anytime you fancy giving your car a quick blast.
Dad and I have been trying to get as much work done as possible over the hols so far. Starting to see the light at the end of the tunnel!
Cheers
Tim
|