Quote:
Originally Posted by TAZ
… #1 There doesn't seem to be an obvious 'this way up'.
That said, the lights only seem to fit in one way, but when fully assembled the hole for the wiring is offset from the top by 10 degrees or so. Is this correct? The buckets are not handed so the hole is outboard on one side and inboard on the other. The adjusters are at the top and to one side, so this seems correct.
So please help to confirm whether it is correct from the photos?
|
Not a Tribute, but a similar headlight bowl arrangement.
Your beam adjustment screws at 9 & 11 o’clock (ish)…
Correspond with the larger holes you can see here at 9 & 12 o'clock, which are the same on both sides.
This is the two part bowl system fitted.
And you can see the rubber grommets for the beam adjusted screws poking through on the other side here:
Hope that helps, Paul.
