I have just painted the inner faces of bonnet and rear clam on my RS200 replica (MRS200 kit) with them fitted to the car (bonnet raised and propped up). I just went for satin black exterior oil based paint as I wasn’t bothered about too thick a finish as I will be fitting wheel arch liners, nor too smooth a finish.
Worked well and the paint was quite thick so didn’t really run. Needed a few acrobat moves to get inside the clam and under the arch areas, but the paint takes about 18 hours to really dry and set so I didn’t have enough space to take my rear clam off and store overnight along with the car itself.
Last edited by SwiftyDS; 8th November 2018 at 07:37..
|