View Single Post
  #11  
Old 6th August 2017, 12:24
micky1mo's Avatar
micky1mo micky1mo is offline
Senior Member
Enthusiast
 
Join Date: Dec 2006
Posts: 1,130
micky1mo is on a distinguished road
Default

Work is still on-going.
The bonnet only just fits over the engine but the brake master cylinder is to high so I unbolted the entire pedal assembly and lowered it by about 40mm.



If you look closely you can see the hole where the clutch cable (on the right) used to go !!

The original rear chassis rails tucks in nicely under the bottom lip of the boot.



With a bit of wood packing the body rests on the chassis rail so well you might say it was made for it



It'll just need a little sealant, a few bolts to hold it in place and the back ends supported perfectly
Reply With Quote