Got a bit more done yesterday and today ....namely some dropped floorpans.
I have made these out of 3mm plate , really strong and they are fitted front and rear at present and seat pan and foot pan are welded together on top of the outrigger to the existing framework ...everything drops in from above so still fully removable.
The seat pans are sloping back for seat angle , but , sitting in it , I think I may fit the seats with a more acute angle ...
As the pans are only fabricated with front and rear attached so far , I made up some angled sections that will cater for the sides ...The very long foot pans will enable me to create lots of legroom as we are not governed by a Triumph bulkhead on this one and I can scratch build to suit.
The bodyshell is being delivered tomorrow , so I should be able to start fabricating a bit of framework and mapping out new bulkhead etc...