Windscreen pillars are now bonded on. Bit more of a challenge clamping these down due to the angles, but seemed to help with alignment that mine were split from the roof panel when my kit was delivered.
Used expanding foam to fill the roof void and also the inner void between the screen pillars and MR2 screen surround. Just need to fill and prime the join each side to the roof panel and refit the windscreen rubber then it’s onto the doors.
In the image below the drivers door skin needs raising slightly when it gets bonded on. Panel gaps aren’t too bad with this lined up, but a bit more work to do on lining up the door skin on the passenger side.