Quote:
Originally Posted by Mike
Hi Peter
I have offered my MBC up to the old one and am certain mine will not foul.
You could fit a thin spacer between the servo and firewall on the two offside mountings, angling the MBC towards your engine to prevent fouling the bonnet side.
|
Hi Mike. Yes I had considered that but I don’t like the misalignment that causes, even if a ball joint clevis is used. If you put a wire down the opposite port it only goes half way across the cylinder so I am pretty sure the redundant outer boss is solid. If it could be Xrayed it would confirm that immediately! Peter.