View Single Post
  #469  
Old 13th April 2020, 21:03
peterux's Avatar
peterux peterux is offline
Senior Member
Enthusiast
 
Join Date: Mar 2005
Posts: 2,875
peterux is on a distinguished road
Default More wiring.........

Jack and Froggy, cheers for the feedback.

------------------------------------------------------------------------------

With the nearside wings in place I could crack on with the front lights wiring. To meet the IVA requirements I needed to securely fix the wiring under the wings. To fix to the GRP wings I made up these pads......... I pop riveted these special cable ties to 4cm square pieces of aluminium. (I've had a packet of these cable ties in my box for years and never found a use before.)

Cable tie mounts by Sabrebuilder, on Flickr

I then glued the cable tie mounts to the front wing with a good dollop of PU adhesive. This time I remembered to remove the black schultz coating and I roughened the surface with some sandpaper.

Wiring pads by Sabrebuilder, on Flickr

I also bolted a cable tie mount to the side of the headlight shell.

Headlight wiring by Sabrebuilder, on Flickr

After painting the support pads and surrounding areas, i have completed the headlight and front indicator wiring.

Headlight and indicator wiring by Sabrebuilder, on Flickr

The side light wiring runs along the upper wing support.

Side light wiring by Sabrebuilder, on Flickr

..and the side repeater wiring runs along the lower wing support.

Side repeater wiring by Sabrebuilder, on Flickr

Now I need to do the same on the offside.......

.........peter
Reply With Quote