Thread
:
Up-dating my McCoy
View Single Post
#
18
1st November 2015, 17:17
pompeyal
Senior Member
Enthusiast
Join Date: Jun 2008
Location: Fareham, Hants
Posts: 161
The Throttle body (cont’d)
This is where the cursing came in
As you can imagine it was very difficult for him to get to some of the weld areas but he kept at it and produced this..
Now to machine the distortion from the flange face
With that done the bores were ground flush to remove any welding and rough edges then it was back to the car to see how it looked
That done the trick, well that was the first saga over with..
On assembling the air temp sensor fouled the injector rail so that had to be dealt with, I ground away the rail but that wasn’t enough, if I went much deeper then I would have broken through into the fuel gallery so other thoughts had to be made.
What I needed to do was machine the boss at an angle to allow clearance, make a new boss so back to the milling machine and then speak nicely to my welder again..
All done now to fit it all together..
Just right….
Last edited by pompeyal; 1st November 2015 at
17:35
.. Reason: .
pompeyal
View Public Profile
Find all posts by pompeyal