A quick general update, hopefully some photos at the end of the weekend as i don’t like showing “part way” mods!
I am using galv square tube and building up the back end extension support area with that and fibreglass. Nearly there. The backend needed to be approx 20mm higher so the front end looked good on the roof. Have also supported the boot extension wings with some bonded in and fibreglassed over 6mm rod. Stiffened up nicely.
As far as the fuel filler that is looking pretty good but I won’t be able to check that until the backend back on and trialled.
I have my sill trims back from production, look really good profile. My job now is to chamfer the ends, make end plates for those and weld in plus weld in the tabs/bolts to hold them on. Keeping on keeping on!
|