Been quite busy with the car just recently and managed at least an hour each day outside having a fettle.
Have done some work on getting everything aligned and closing in the shut lines. It's quite slow work and the driver's side seems to be much better than the passengers but it'll get there. Doors are now in just about the right place and have made up some brackets to go inside to push them out to the right place to meet the side skirts. Have also made up brackets to hold the skirts in place and now started on some more for the front bumper.
I've also sprayed up a couple of bits in the engine bay, hinged the bonnet and strapped it so it doesn't open too far. Pictures of stuff below.
I've gone back to looking into hinging the rear end although it'll be a little less elaborate and a little more wobbly (when open) than Wozzys frame that he's made. The main issue is the crash bar is too deep so you'd need to remove some of the clam to clear it. My plan is to get hold of some thinner box section and make up my own shortened less deep crash bar because I just don't want to cut the clam about. It may work, it may not...
Last edited by Nostromo; 28th October 2017 at 11:41..
|