They're actually pretty good but more through luck than anything else. It's not that easy to explain (I'd take a photo but I'm at work) so at the rear edge of the door, I've managed to trim the door skin so that the top half of the mr2 door is inside the door skin, and the bottom half is outside of it which pushes the bottom of the skin outward and the top of the skin in then I've bent some brackets to space the bottom of the mr2 door out a touch more to meet the side skirt. I hope that the addition of bit of rubber door seal at the top will give it some extra rigidity as it'll push the top of the door out a bit more.
I'll take a photo this weekend.
Last edited by Nostromo; 28th October 2017 at 06:29..
|