Spent all day sanding the guide coat off with 320 grit removing small indentations and scratches from the previous sanding bout, i can see why a respray cost a lot, it takes so much time to get a good flat surface.
IMG_5460.jpg
The area circled is a low point (the black is the guide coat) which was not so visible prior to the guide coat going on, thought i would share this with those of you that have never used a guide coat.
IMG_5461.jpg IMG_5458.jpg
Just about there removing the guide coat. Surface is now smoooooooother and flat, there are a few small area's which need 1K filler putty applied, small pin holes etc once these are sorted the plastic bond coat will be applied followed by high build primer which mean's more sanding before the top coat's are applied, oh happy days but it does look better than with the guide coat. :eusa_wall
Well that's it for now see you all soon.