[Yorkshireman]

So with a sunny morning car was pushed out of garage.




When i left the car I had bonded on the body and decided to leave it for the month to bond. While at work I came up with an idea to bolt the body as an extra security to the spitfire side bumper mountings. this was for two reasons one to hold the body as well as the bonding agent and two to postion the rear arches in the correct postion.










The first photos shows the body and the measurement need to have a uniformed distance on both sides of the car. So with using the countersunk set screws I was able to set this and lock it all in place and add some extra strength but not sure if its over kill or not. With using the countersinks I can blend them into the bodywork at a later date. Also at this time I replace the selftapping screws with poprivets so thats the main body now fitted to the car.