View Single Post
  #87  
Old 30th December 2017, 18:42
lancelot link's Avatar
lancelot link lancelot link is offline
Senior Member
 
Join Date: May 2009
Location: POOLE , DORSET
Posts: 2,200
lancelot link is on a distinguished road
Default

Removed the brace bar this morning cut some end boxing pieces , bonded and glassed them into place ..after a trim , some latch fitting holes drilled etc. and a quick sand , the underneath of the bonnet can be flowcoated to make it a nice uniform finish


gif free upload

I also re-instated the exhaust that was removed , cleaned up and painted satin black ... and put some fixings in to hold the body on ...

As a footnote ..the bulkhead panels that I have templated are going to be available in aluminium as a full panel with swaige lines pressed in , very similar to the bulkhead on Graham's car , they will be supplied in 2 halves with a joddled edge on one panel allowing the other one to lap onto it nice and flush and a single row of rivets can join the 2 together ... ....prices to be confirmed .....

Last edited by lancelot link; 30th December 2017 at 18:58.. Reason: added a bit of blatant merchandising to end of posting
Reply With Quote