[MartinClan]

Originally Posted by Mike

However, may be a way round this is to make a batch of adaptor plates with the large centre hole, and the two holes to attach to the servo, and the cut out for the vacuum elbow: but not include the master cylinder fixing studs.
Each user could then drill two holes to match their own master cylinder, and fix with counter sunk set screws? There is no need to ensure a vacuum seal, so as long as the screws are seated below the face there will be no problem.

Is anyone interested in this option?

I don't know what the cost would be, but if I can get 10-15 made locally they shouldn't be too expensive in self colour.

Put me down for one of those as well please :-)

Cheers Robin