2nd October 2016, 18:02
|
Senior Member
|
|
Join Date: Aug 2012
Posts: 2,142
|
|
Quote:
Originally Posted by Jeff H
Yes Steve,
The trailing edge is about 2-3mm thick, it needs to be thin so that the door wont hit as it opens.
I knock the filler down with 80 grit to start, then I finish off with 120 followed by 240, the Reface will cover a multitude of sins, pinholes, scratches etc, I still have some small pinholes to fill this will be done with a fine filler before the final primer.
The other thing is the Reface wont go thru a normal gun, it needs to have a 2.5mm or 3mm setup, it goes on with a very rough finish.
|
I was going to use Reface on my Triumph Roadster but I'm not sure now. It says it can't go over aluminium so I've etch primed the car but it looks like you can't use it over etch primer. So I've gone over it with standard grey primer but this is an acrylic paint which might not be good under Reface either !
|