What method is best to fit the floorpan?
I have a number of options
- 1. Rivnut
2. Pop rivet
3. Self tapper
4. Panel bond
Which ever I decide, I am going to use panel bond. This is firstly to create a watertight seal between chassis and floorpan and secondly for strength.
So I suppose the question is more to do with whether I need anything else and if so what?
I was happy to use widely spaced self tappers initially, until I saw a picture where rivets where used. I do see a problem with rivets, which is the need to seal the holes after.
Any and all suggestions welcome.
Merry Christmas and Happy New Year!