Thread
:
JoeB's Z300S Build
View Single Post
#
2
16th November 2017, 02:16
JoeB
Member
Join Date: Nov 2017
Location: Coventry
Posts: 36
It all started off as a 2.8 manual Z3 that I found on autotrader which was suitable.
Here are a few photos of when I first got the kit from nubodi and started placing the kit on the car.
The day I collected the kit was the day my new steering wheel arrived in the post too!
All it needed then was a piece of aluminium, a wheel centre cap and an hour or two on the lathe until it was ready to go in the car.
Once the panels were placed on the car I then went about deciding how I wanted the rear lights to be arranged and I also started mocking up how the exhaust would sit.
The exhaust is from a 2015 BMW M4 that had a small amount of damage to one of the tips. I will be changing the tips so this doesn't really matter to me.
The M4 exhaust has bypass valves built in so hopefully I can get these working with the car at some point in the future.
JoeB
View Public Profile
Find all posts by JoeB