I used a long bed hand sander bought from Ebay for about £10, uses hook & Loop so easy to use.
With 80 and 120 grit it made short work of any section that was undulating or needed blending. I then used 320 for final smoothing using a small head held sander from Ebay for about £15. I also bough a block set, again velcro that has different curvature blocks for smoothing out the curves. As luck would have it the hand held blocks also attached to the little velcro sander so not too much hard work.
I did find it helped to mark sections with a felt tip pen, that way you are sanding a manageable area.
After the 320grit I applied the ReFace and that seemed to cover almost all of the sanding marks.
Yours is looking far better, theres light at the end of the tunnel.
|