First fit, won't go on with the bumper still attached so will have to remove it first. Just wanted to get an idea of what to chop about first. As you can see from the photo, quite a bit of the rear deck has been removed and replaced with softboard. I have fitted a metal brace underneath to keep it all steady.
I have ordered so clear pvc table protector, I intend to use this to mark out the rear deck and then cut it out and mould it in grp to allow me to build up the rear deck again, hopefully, it will work.
Rear wheel arches glassed back in, the wheels that I have fitted are slightly wider than standard so I'm hoping that the shell being slightly wider than the Z3 will work.
If you look carefully you will see some alloy tape holding the front section together. It is what the airlines use to repair the baggage trollies (Ryanair & Easyjet use it to repair planes). It is very strong and sticky and ideal for forming temporary edges that you can use to make a mould.