I had a quick master class from Mike when I went down there last week.
1. Mix up some bonding paste and some resin, you will use both.
2. paint some resin in the corners and along the edges as that will fill any voids
3. Rip up some lengths of matting don't cut it straight or you will get an edge
4. Pre-Soak some matting with resin on a seperate flat surface as it will make it a lot easier to manipulate and stick
5. Place your soaked matting where it needs to go and push it into the corners and edges onto the bonding paste. The paste will help it stick and fill the voids.
Well that's the theory!
|