View Single Post
  #8  
Old 6th December 2019, 12:33
Crofty Crofty is offline
Junior Member
 
Join Date: Jan 2014
Posts: 15
Crofty is on a distinguished road
Default One step forward and one step back

Hi, thanks for all the help, managed to drill headlight covers, I started with a 3mm drill dipped in washing up liquid very slowly and then used a stepped drill usually used for drilling bigger holes in sheet metal,drilling slowly with it dipped in washing up liquid. That part was successfull ,but when I drilled the top hole on the fibreglass body it was very thin and shattered. Any ideas what to use to repair it with remembering I am going to drill it and put threaded rivets in. Thanks regards Andy
Attached Images
File Type: jpg 1819A27B-355F-4C60-A620-CF280EFD0379.jpg (17.2 KB, 58 views)
File Type: jpg AD651E76-8392-4DA4-92C2-D1014CA94C90.jpg (17.3 KB, 48 views)

Last edited by Crofty; 6th December 2019 at 12:49..
Reply With Quote